The approach for methods to remove drywall texture depends on the material being removed and the condition of the wall. If the drywall seams have utterly cracked or break up open there may be a structural downside that must be re-mediated earlier than you repair the drywall seams. Once the tape is in place, you can begin making use of joint compound using one of the putty knives. Hence, when you can paint a whole part of the wall, as much as a corner or seam, the distinction of “new” versus “old” paint is less visible.

This hardly ever leads to a good floor and makes for additional time and mess during the sanding phase. 1. Depending on the quantity of drywall repairs required, take away an appropriate quantity of joint compound (or “mud,” as it’s generally referred to) from the plastic tub using your four” drywall knife and scrape it off into your 12″ mud pan.

However if you have a larger hole it might be simpler to install a big new piece of drywall that runs from one stud to another. With paper, unfold a thin coat of mud over the seam, the, using a drywall knife; press the tape into the mud and over the seam.

The most important tip for purchasing drywall compound is to buy sufficient. Wherever the tape overlaps, place a small amount of joint compound over the underlying tape. The navy-blue-on-white savoy pattern (Picture 1) was a nice paper that had been hung, unfortunately, instantly on new Sheetrock, and not using a wallcovering primer, nor even a coat of paint.

2. Put together the hole space by chopping off any unfastened paper or loose pieces of gypsum with a utility knife. It’s essential to put on the primer, because uncooked drywall and joint compound, when painted, will dull the finish of the paint and give away your patch job.